Search results

If it's not already done, I'd pay off debt. Assuming it is done, I would start a small business.

I did. I still had ears on so I can't be too accurate on sound. But it was noticeably quieter than the other 9mm subs I shot that day.

I'll be different. The KGmade Swarm sounds great and can be used in a short configuration.

SR-25

I agree. The echo trigger accomplishes basically the same thing without electronics to fail. I do plan on getting an echo trigger eventually.

I get that open bolt is a great system for machine guns. I meant that you don't need to find a practical purpose for an open bolt machine gun.

I talked to him about it too.

I can't wait to take one of these classes in a few years.

"Practical" and "open bolt" don't belong in the same sentence. How difficult would an integral .22LR AR barrel be to make out of curiosity?

I couldn't get over how reliably it ran.

Garand for sure. .45-70 is cool and all but I've heard a bunch of folks say they don't shoot them much after first get them for the reasons laufen said.

That sounds like the best idea. Thanks

Yeah I don't want bulk. But I figure if I can have ballistic protection for not much more weight than just a chest rig it wouldn't hurt. Getting the plates for free is also a big reason I'm doing it.

These plates are thin and light (under two pounds for both). The front is shooters cut and I only plan on putting two single Mag pouches and a small IFAK to keep bulk and weight to a minimum.

That's where I'm at with it. Realistically condor would probably work. But if I can spend not a whole lot more for something better then I'm interested

I have some level IIIa hard plates on their way to me. I need to find a carrier for them though. Looking for a balance of quality vs price. I want it to hold up but I'm also not going to war with it. I would like something low profile that I can throw a few mag pouches on. Any suggestions?

My dad got to shoot full auto for the first time today. This is him with my BCM upper on a Full auto lower I can say not only does my rifle run steel cases perfectly fine so far, it does just fine with a giggle switch too. Sent from my iPhone using Tapatalk Pro

I may take you (and her) up on that when I get the funds saved up so I can make sure I like it before I buy it.

Sweet. I think it is the route I'm going to go for a precision gun. I think it will fit my needs perfectly.

I'm more concerned with the bolt reliability feeding from AR mags. The bolt is a little funny looking.