Looking to start reloading?

Howard Law

freedom

Sniper
Mar 25, 2015
1,522
885
113
Covington, Ga
Zip code
30014
Don't do too much too fast. Pick one cartridge and work on everything before you start branching out.

I'm new also. 223 & 308 both seem pretty idiot proof and would be hard to blow yourself up with as long as primers are seated right.
 

Sheps

Woodsman
Jun 24, 2015
137
80
43
www.youtube.com
Zip code
en5 1ae
I don't personally know dick about reloading but I do know guys who do it and gunsmiths/armorers who have to fix the fuckups. You need to get some quality published literature, can't remember it's name but it's the universal "Big book o' reloadin'" and you need to consider it your new bible.

If you're one of those guys who doesn't have a shred of OCD about him, you can live and work in chaos then maybe this isn't for you. It can get dangerous if you double charge or mix up powders etc.
 

freedom

Sniper
Mar 25, 2015
1,522
885
113
Covington, Ga
Zip code
30014
Not fully searing the primers can cause an out of battery discharge. The rest of the bad stuff that can happen comes from using the wrong powder or too much of it. The powder charge for 223 or 308 fills the case. If you don't have any pistol powder to accidentally load in your rifle case you won't blow your gun up.
 

Woodstock

Tracker
Jun 29, 2015
529
189
113
Zip code
30012
start with a straight wall pistol case, pay attention to details and measurements. Crucial stuff.
Do one operation at a time. such as deprime and size, then prime etc
 
  • Like
Reactions: Richard P. Musgrove

Liberty

nitrocellulose dispenser
Site Supporter
Mar 27, 2015
697
612
113
Ga
Zip code
31901
I would show you, but that is a long drive. Read the Hornady or Sierra manual; they are both filled with great ballistics/ how too info. Start with .45acp, the most forgiving/low pressure round commonly used. Then be careful.
 

dial1911

Waiting for the flash
Site Supporter
Jul 15, 2015
7,331
27,066
113
Anywhere but here
southeastoutdoors.boards.net
Personally I'd recommend starting with a used single stage press. Starting with the single stage lets you get used to all the steps- using a progressive press takes a lot of attention just to be sure of what you're doing. However once you are used to it all and have rolled a couple thousand rounds, you'll be much more used to the process and it will seem more automatic.
 
  • Like
Reactions: Richard P. Musgrove

Sheps

Woodsman
Jun 24, 2015
137
80
43
www.youtube.com
Zip code
en5 1ae
Don't do too much too fast. Pick one cartridge and work on everything before you start branching out.

I'm new also. 223 & 308 both seem pretty idiot proof and would be hard to blow yourself up with as long as primers are seated right.
Would like to hear from the experienced guys but I would THINK, this is the wrong way to go, no?

So if you're going to get into reloading, shouldn't it be for less common, less available/cost prohibitive rounds?

Thoughts?
 
  • Like
Reactions: Richard P. Musgrove

freedom

Sniper
Mar 25, 2015
1,522
885
113
Covington, Ga
Zip code
30014
Would like to hear from the experienced guys but I would THINK, this is the wrong way to go, no?

So if you're going to get into reloading, shouldn't it be for less common, less available/cost prohibitive rounds?

Thoughts?

For .223 you can load 77gr match ammo for about the price of brass range ammo, that stuff is well over a buck a round when buying factory ammo.

The only things I reload is 223 and 308, and they do seem pretty idiot proof, I didn't want to comment on a round I didn't reload.

My main advice is to pick one round and get all the kinks out of your system, before you branch out into others, and I do think that's good advice.
 
  • Like
Reactions: Richard P. Musgrove

Sheps

Woodsman
Jun 24, 2015
137
80
43
www.youtube.com
Zip code
en5 1ae
For .223 you can load 77gr match ammo for about the price of brass range ammo, that stuff is well over a buck a round when buying factory ammo.

The only things I reload is 223 and 308, and they do seem pretty idiot proof, I didn't want to comment on a round I didn't reload.

My main advice is to pick one round and get all the kinks out of your system, before you branch out into others, and I do think that's good advice.
I didn't mean to make it sound as if you were doing something wrong. At least that was not my intention. Also wasn't trying to suggest you couldn't save money, or I guess make better use of it would be a better way to put it.

Just seems to me (in my ignorance) it might be a better use of that investment for rarer rounds. Like I dunno, historical junk. Or maybe if you shoot 7mm08 and that's expensive in your area. You just neck down .308 and boom, you got your rounds...

Again I'm asking questions like this because I don't know what I don't know about reloading, ya know?
 
  • Like
Reactions: Richard P. Musgrove

dial1911

Waiting for the flash
Site Supporter
Jul 15, 2015
7,331
27,066
113
Anywhere but here
southeastoutdoors.boards.net
Would like to hear from the experienced guys but I would THINK, this is the wrong way to go, no?

So if you're going to get into reloading, shouldn't it be for less common, less available/cost prohibitive rounds?

Thoughts?

I can reload a box of 9mm 115 grain HPs or RNs for about five bucks- saves about $7 over store bought ammo. Not a ton of savings... however I can reload a box of 147 grain subsonic 9mm's for about the same price- much bigger savings (I don't know exactly what subs sell for- I've never bought them from the store).

Once I buy the die set, I'll be rolling out .300 BLK rounds at a cost of about 0.20 per round. Beats the hell out of about 0.75 per round when you can find them at the store.
 
  • Like
Reactions: Richard P. Musgrove

freedom

Sniper
Mar 25, 2015
1,522
885
113
Covington, Ga
Zip code
30014
I didn't mean to make it sound as if you were doing something wrong. At least that was not my intention. Also wasn't trying to suggest you couldn't save money, or I guess make better use of it would be a better way to put it.

Just seems to me (in my ignorance) it might be a better use of that investment for rarer rounds. Like I dunno, historical junk. Or maybe if you shoot 7mm08 and that's expensive in your area. You just neck down .308 and boom, you got your rounds...

Again I'm asking questions like this because I don't know what I don't know about reloading, ya know?

You will not save money reloading, if that's your intention I wouldn't do it.

How many rounds of 7mm/08 will you shoot in a year? How many years would it take to make up the costs of presses, tools, dies, etc? Still I get what you're saying, one day I'll probably load 7.7jap among others, but I'm leaning to load what I shoot the most.
 
  • Like
Reactions: Richard P. Musgrove

Kyle Turner

Formerly "Palmettomoon"
Aug 16, 2015
30
93
63
Macon
Zip code
31211
To start, as others have stated try a straight walled pistol cartridge first. The bullets and brass are inexpensive and you'll learn prep methods, weighing charges, seating the bullet, putting on a taper crimp, etc. Basic stuff. After a while, you'll branch out into other cartridges or you'll quit reloading. That's my experience with other reloaders. When you start getting up at 4:00 a.m. to cast your own lead rifle bullets to "beat the heat" of summer, you're gone man....gone.

Reload uncommon rifle cartridges to save some money but the real reason anyone should reload rifle or pistol for that matter is that YOU control everything. Get a chronograph so you can confirm what you are doing against the manuals (and you should buy/read several). I can buy .577-.450 Martini-Henry cartridges from Buffalo Arms when they have stock for about $175 a box of 20 or I can load them myself for about $10-15 per box of twenty after I buy my brass. I value my time highly but I can roll my own for a $160 savings.

The main thing is you can control your MV and pressure, select slower or faster powders since every rifle is different, load mid range wadcutters for pleasant target practice (they aren't commonly found now). There are a LOT of reasons to reload. As a bonus, its fun.
 

Jcountry

Frontiersman
Mar 30, 2015
350
194
93
Georgia
whats up guys. ive been wanting to get into reloading for a while now. any and all advise would be appreciated


I read the Lyman book and the ABC's of reloading.

I would recommend a single stage to start out with. Easy to control each step in the process.

Take your time, and do it right. Don't reload when you are in a hurry or distracted. Don't drink while reloading.
 
  • Like
Reactions: Richard P. Musgrove