Preparedness Depot in Acworth, GA

What do you do

  • Hover

    Votes: 3 12.5%
  • Wipe and sit

    Votes: 10 41.7%
  • Birdnest

    Votes: 5 20.8%
  • eww, i'm to uppidy to use a public tiolet

    Votes: 6 25.0%

  • Total voters
    24

Miles

Ninja
Site Supporter
Kalash Klub
Jul 20, 2016
8,384
46,778
113
NW GA
I cant get this damn screw out. I might need to actually send this lower off to have the screw removed

View attachment 70360
Heat the the receiver it with a blow dryer set on high.
If screw is steel and receiver is aluminum, put it in the freezer for 2 hours, then heat the Receiver, not screw. As aluminum expands, it will break a bond with the steel screw. Screw hole will be bigger when aluminum is heated, steel bolt smaller, when cold.
I had to do it to a BCM rail that BCM put on with red locktight on the screws. Stripped the torx bit at first, but cold and heat worked.
 

Old Skool

Tracker
Site Supporter
Oct 14, 2019
996
6,726
113
Georgia
If you ever lived in Orlando, at some point you've worked for Disney.

I valeted/bell services, and I was a bartender at the clubs at Pleasure Island too.

At Disney, I used to tell people "Have a magical day".

It meant two things. I was either being genuine and then it was funny because the way I look doesn't match that statement.

That's also how I'd tell a guest to go fuck himself, "Ok, you have yourself a magical day sir"