Has anyone actually decoded the material differences between the offerings at PSA?
Should I just go cheap for a Machine Gun upper?
Should I just go cheap for a Machine Gun upper?
PTAC, PSA freedom, and PSA- whats the difference?
- Thread starter PewPewPewCo
- Start date
- Jul 5, 2015
- 6,135
- 30,134
- 113
- Zip code
- 30022
I would definitely go cheap on the upper and definitely shoot steel case ammo. But I'm cheap like that.
The cost of the upper compared to the registered MG is miniscule. The rest is cost of operation, which can add up quickly if you do a lot of shooting.
The cost of the upper compared to the registered MG is miniscule. The rest is cost of operation, which can add up quickly if you do a lot of shooting.
DoglegArms
Silencer Dealer of 2015, 2016, 2017
IMO Probably none. I think the differences are in fit. But I haven't the freedom line in person.
Rob Ski tested the Freedom PSA and it did pretty damn good. PTAC is junk, I don't care what anyone says. Of course, if CHF and CL barrel is important to you, then the extra $100-150 on the Premium line is worth spending. I prefer nitrided or other corrosion protection for less that does as good of a job. PTAC was 1/9 and Freedom is 1/7 twist mostly. They also have the Stainless series.
I say if you're going budget, then Freedom makes more sense.
I say if you're going budget, then Freedom makes more sense.
Well I'm think the freedom line with like a 10.5" barrel will fit the bill.
My other uppers can get moderate use
My other uppers can get moderate use
