Any regular SET members do NFA engraving?
- Thread starter Laufen
- Start date
That's actually pretty funny. I've got one approved that needs to be engraved. I might seriously let my 12 year old son do it with the Dremel.
Lqtm because I had one of those POS's and can tell you it for sure doesn't belong on that noveske rifle.
Sent from my Obamaphone on Tapatalk
I'm not personally a fan of them, but would you say that you used one enough or trained with one enough to become proficient with it? Did it cause problems?
No not at all because it was so cheap feeling. I ripped it off the second I installed it. I actually knew better the second I got it out of the packaging. There has got to be a sturdier less wobbly and terrible feeling option.
Sent from my Obamaphone on Tapatalk
Maybe, that's your rifle not the lever.... but WTF do I know.
I did get a laugh at....
There are similar products that are one-piece designs. But you kinda confirmed what I thought. It's not for everyone and if you're going to use one, you better train with it. Because it's a totally different manual of arms. Not a bad idea, but not for everyone either.
Don't dismiss something based solely on fit / finish though. The levers primary weakness is that it attaches to a part that can vary widely between manufacturers. Some are loose and floppy, others fit better depending on the bolt catch.
There are downsides though. The different manual of arms being one. If you use it, use it on every gun. Other folks have had legitimate failures caused by it too. In some cases, it can cause a failure to lock open on an empty mag. But others have used it for years without a problem. So that's a gun specific issue.
Different strokes for different folks and all that jazz...
