Any regular SET members do NFA engraving?
- Thread starter Laufen
- Start date
Factory SBRs?
Also, which model is the top 1? .308?
I can see the middle is a gen 1 and the bottom is gen 3.
Unless the form 1 has been approved, it's still a regular lower. Engraving doesn't make it an NFA item, so anyone can transport it. Engraving simply makes it compliant once the forms are approved. Form = SBR
If it's an approved form 1 lower, then it has to stay under the owners control or in the possession of an SOT.
It's been approved. @Laufen screamed it from the mountain too earlier.
I say it could be a gray area if laufen put a 16" barrel on it then he could cross state lines without paperwork bc it is no longer an SBR. That same logic could be argued to also be applied in this situation.
I wouldn't wanna be he guinea pig.
OK. Missed that earlier.
He's going to have to transport in person or ship it direct to an SOT, as a lower only.
But you're right, attaching a 16 upper technically makes it a Title 1 gun and could be transported. But like you said, I wouldn't want to be the test case.
Sent from my SM-G920V using Tapatalk
Yeah, but he said "Regular Member".
Are you saying Bryan isn't "regular" or just not active...
Dang. I didn't realize that was a 12.5. And with the Brakeout 1.0? My ears hurt just looking at it. But suppressed, that has got to be a sweet setup.
Sent from my SM-G920V using Tapatalk
Yeah but I shoot everything suppressed anyways.....
I never shoot it, if I'm going to shoot .308 I shoot da G.A.P.
