300BLK Suppressed SBR Done!!!
- Thread starter DoglegArms
- Start date
Get a set of Grace USA roll pin punches. They have a centering tip that make driving them in with ease. They are inexpensive but still very strong. You only need to oil the pins and drive them in. If they don't go in smoothy, clean the receiver holes using the prober size drill bit using a hand drill. Makes life much easier.
To be fair, haven't you had two out of spec Noveske lowers?
Also, my KAC lower is getting mailed back for being defective too... :-/ Bolt catch tab broke off!
Sure did. They were both chainsaws too. I wasn't knocking Aero. I've built up several and only had one with an issue. And I forgot to point out that all it took was a phone call to get a new one shipped to me. And Aero didn't even ask for the defective lower to be returned.
Shoot the subs wet(water put in from the expansion chamber side) to tame that first round pop
The one outside was right after shooting inside. I didn't think there would be a FRP.
It wasn't actually "loud", it was louder than my 762 cans and Dobbs 30 can. It was way below hearing safe, just not 22LR quiet.
I need a can for my M4 style rifle, but it going to have to be something that will go over a GI flash hider, since the flash hider is permanently attached. Any suggestions?
We better get @DoglegArms in here for this 1. I think Rugged & Gemtech has options I'm sure there are more though. @PewPewPewCo could help also.
Just failed. I started to notice the bolt not holding open on empty, and then it stopped feeding the next round almost at the same time.
Got home, took it apart and you can see it was a poorly made part. Looks almost like pot metal and the tang just broke. I didn't realize it until I got home as I was with some friends setting up 2 new AR's he got. I posted a pic in my Mod2 review on here.
Weird part, I put the E3 bolt, cam and firing pin into my PSA carrier and it cycled just fine when at the range. Obviously with the bolt catch broken, it still did not lock back on empty, but started feeding correctly.
Not sure what is up as I still have to inspected everything to see if it's something obvious. I didn't want to hold my bud up with his new AR so I just stuck it back in the case for later and saved some of the brass to inspect just in case too.
I am mailing the lower back to Ayan as I figured he is certified so I don't risk anything with the warranty.
Just sucks to pay that much and deal with issues. At least my PSA ran fine as well as my friends two new Premium Mid-length PSA he put together ran well too.
Hopefully I can do some investigating this weekend sometime to trouble shoot what is going on.
Lastly, the FTF was with Xtac, American Eagle M855, and cheap Wolf my bud had. At least I can rule out ammo for the most part...lol
I'm liking the Gem tech, at the moment... Just need to put away $750 bucks, and $200 for the stamp.
Griffin 30SD is popular. It's a nice can.I'm liking the Gem tech, at the moment... Just need to put away $750 bucks, and $200 for the stamp.